Kit Contents/service Parts:

  • 1 Cruise Control Module 250-2888
  • 1 Pedal Interface Harness 250-2804
  • 1 Brake Switch Harness 250-2759
  • 1 Control Switch 250-2867
  • 1 Diagnostics Harness 250-2783

General Applicability:

  • This Cruise Was Tested And Verified On:
  • Ford Transit 2.0 - 2.5 Liter Only

Recommended Tools:

  • Personal & Vehicle Protection
  • Safety Glasses
  • Special Tools
  • Volt-ohm Meter
  • Installation Tools
  • Trim Removal Tool Phillips Screwdriver
  • 10mm Wrench
  • Drill Bits 9.5mm Or 3/8” (For Switch)
  • 14mm Wrench
  • Soldering Tool
  • Special Chemicals

Hardware Bag Contents:

  • 8 Wire Zip Ties


  • Do Not Use Hand-held 2-way Transceivers Inside Your Vehicle While Driving.
  • When Transmitting From Inside The Car, 2-way Radios That Operate In The 25mhz700mhz Frequency Range With More Than 2.0 Watts Of Power Can Produce Electromagnetic Interference That Could Interfere With The Operation Of Cruise And Throttle Controls Resulting In Vehicle "Limp Mode".
  • Use Of Cellular Phones Will Not Interfere With These Controls.
  • Due To Sensitive Nature Of Signals Used For This Product, All Non-plug And Play Connections Must Be Soldered. Failure To Comply With This Requirement Will Void Warranty.

Before Installation:

  • To Make The Installation Easier The Complete Installation Instructions Should Be Read Through Before Installation Is Started.
  • This Installation Instructions Contains Information How To Install The Electronic Cruise Control Which Is Not A Do-it-yourself Job.
  • Modern Cars Are Equipped With Electronics Which Can Be Costly Damaged By Inappropriate Treatment.
  • Rostra Precision Controls Can Not Be Held Responsible For Any Error Caused By Improper Installation. 

Stop - Read Before Installation Important Advisory Notes That You Must Follow :

  • Always Disconnect The Negative Cable From Battery Before Installation.
  • Always Use The Enclosed Installation Instructions For Installing The Electronic Cruise Control.
  • Check The Part Number Of The Cruise Module Label Is The Same Compared To The Part Number Of The Installation Instructions.
  • Be Aware Of Radio Codes That May Have To Be Entered.
  • Find A Location To Install The Cruise Module And Control Switch.
  • If Any Wires Are Left Then Cut Off And Insulate.
  • Only Use A Multimeter To Measure Voltage.
  • Always Drive The Car For A Complete Test Before Re-assembling The Car.
  • All Wire Leads Must Be Soldered. 

Brand: Rostra Accessories

  • 2019-2022 Ford Transit Connect
  • 2019-2022 Ford Ranger



Added to cart successfully!