Note: Will Only Fit 4-1/8 axle
Features:
- 100% bolt-on design for easy installation.
- Bump stop extensions properly limit up-travel, protecting your vehicle.
- Heavy-duty upper and lower control arms improve strength and articulation while correcting caster.
- Heavy-duty front track bar bracket correctly positions front axle under vehicle.
- Steering components included to ensure smooth post-installation operation of steering system and factory-consistent vehicle handling characteristics.
Quick Specs:
- Front Lift Height 5in
- Rear Lift Height 3in
- Front Lift Method Coil Springs
- Rear Lift Method Cast Blocks
- Lift Type Lift Kit
- Wheel Size 17 x 9
- Back Spacing 5in
- Max Tire Size 35 x 12.5
- Wheel Size 2 18 x 9
- Back Spacing 2 5in
- Max Tire Size 2 35 x 12.5
- Wheel Size 3 20 x 9
- Back Spacing 3 5in
- Max Tire Size 3 35 x 12.5
- Finish Powdercoat
- Metal Cutting Required No
- Accommodates Factory Wheels See Notes
- Welding Required No
Include:
- All Necessary Mounting / Installation Hardware
- Bump Stop Extensions
- Coil Springs
- Control Arms
- Dropped Pitman Arm
- Rear Lift Block & U-Bolt Kit
- Sway Bar Relocation Brackets
- Track Bar Relocation Bracket
Important Notes:
- Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2€� taller ride height, so net lift gain will be 3€� over stock.
- Check Rear Axle Diameter: This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
- Factory wheels fit when paired with factory / original equipment tire size.
- Fitment This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
- Gas Enginedels may sit slightly taller than the advertised lift height due to lighter weight of engine.
- Lift Block Selection: These trucks are typically between 1in and 3in tail high from the factory. Please measure your trucks factory front-to-back ride height and order the rear lift height to achieve the desired stance. If closer to 1in tail high from the factory order the 5in rear coils for a more level stance. If closer to 3in tail high from the factory order the 3in rear coils for a more level stance.
- This truck was produced with different rear axles. Be sure to measure the diameter of your rear axle before ordering.
- Two-piece rear drive shaftcarrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
Go big and go anywhere with this 5in Lift Kit for your truck that gives you clearance for huge tires up to 36in. This kit has everything you need to raise and level your 4WD 2010 - 2012 Dodge / Ram 2500 Truck. If you€™re going to do it, do it right.
Brand: Zone OffRoad
- 2010-2012 Dodge Ram 2500
Document
Video
- Some one
- New York